The technology of our vertical ALLROUNDERs can be matched precisely to your specific injection molding tasks, while still maintaining maximum ergonomic efficiency. Shot size: 1.2 oz | Us tonnage: 28 | Mold height: 5.9"-11.81" | Open stroke: 7.87" | Platen size: 13.46"x9.84" | Screw stroke: 3.94" | Ejector stroke: 2.36" | Distance between tie bars: 8.7". © 2020 PlastiWin Capital Equipment LLC. Arburg 221M, 28 Ton Injection Molding Press, Fixed Clamp, New in 1996, Voltage: 230, S/N: 166862 **Located in Camarillo, CA** Auction Details Surplus Assets to the Ongoing Operations of Two Major Manufacturers. Your entries are directly checked for completeness and the logical positioning for the relevant process step is always displayed.to the technology, Cable grommetThe versatile six-axis robotic systems offer perfection in motion, enabling you to reliably perform even complex tasks – as demonstrated most impressively by the fully automated encapsulation of cables: the flexible parts are individually pre-assembled and inserted into several cavities in different positions.to the molded part, ClipLeadframes can be encapsulated with plastic using the reel-to-reel process.
We do not pass this data on to third parties outside the ARBURG organisation.
Removed From Press In Working Condition.
Tonnage 27.6 Removed From Allrounder 221-M For the production of clips, a vertical ALLROUNDER 275 V is equipped with a combination mold, which separates the finished parts from the carrier strip. A Scara robot provides 14 delicate pins, which are encapsulated in the mold.to the molded part, Soccer boot soleModern soccer boots are made almost entirely from plastic. The process impresses with short cycle times and uninterrupted high quality.to the video, Fuel tank strainerA vertical ALLROUNDER 375 V shows how fuel tank strainers can be produced in small batch volumes cost-effectively and to high quality standards by integrating manual operations and using innovative working methods.
All information will, of course, be treated confidentially. PROGRAMMABLE TEMPERATURE CONTROLLER, Available Immediately Inserts can be ergonomically encapsulated with our vertical ALLROUNDER injection molding machines. - Terms & Conditions. We are the top source for used injection molding equipment, used rotational molding machines, used thermoformers, extruders and used
Injection pressure: 20,155 psi